https://pfspipe.ipmu.jp/jira This file is an XML representation of an issue en-us 8.3.4 803005 13-09-2019 https://pfspipe.ipmu.jp/jira/browse/INSTRM-1596 Instrument control development <p>asking a wrong position of dcb filterwheel does not raise an error</p> <p>so the sequence continue with an unknown filter wheel position </p> <p>running an other cmd to the filterwheel will raise an error saying for wheel is not init</p> <p>so it should raise an error at the first command saying smthg like "position does not exist"</p> INSTRM-1596

asking a wrong position of dcb filterwheel does not raise an error

Bug Normal Open Unresolved arnaud.lefur fmadec SPS Fri, 6 May 2022 13:15:29 +0000 Fri, 10 Jun 2022 14:21:59 +0000 ics_dcbActor 0 2 <p>Can you point me out which command should have failed ? <br/> I looked at the logs briefly, and see set linewheel command with values in <span class="error">&#91;2.0, 4.0, 12.7&#93;</span><br/> According to the config file, those positions are all valid :<br/> qthHoles = none,0.7,1.0,2.0,4.0<br/> lineHoles = 0.5,1.0,2.0,4.0,12.7</p> <p> maybe the config file is wrong then ?</p> <p>config is ok.<br/> in a sequence (using sequencePanel) we can enter a wrong command for example 2 instead of 2.0 and this will not raise an error immediately</p> <p>ah okay.<br/> I actually did it on purpose, I though that 2 -&gt; 2.0 was a clear enough translation.<br/> I can easily remove that.</p> <p>euh, well there is smgth wrong here<br/> so I am confused now, so let me try to clarify what I saw.</p> <p>I did run a sequence where there was a dcb set linewheel=2, no error was reported, but on the GUI, the wheel position was 'unknown" so the next sequence with also a dcb set linewheel smght failed.</p> <p>so my point was that if the filterwheel position is unknown after a command it should raise an error.</p> <p>let's try to reproduce that error (in fact errors because it happened several times)</p> Development Rank 0|02qpjd:00xznup3i