[INSTRM-873] Test if sm2 red exchange mechanism behaviour is similar to sm1 one Created: 08/Jan/20 Updated: 23/Jan/20 Resolved: 17/Jan/20 |
|
| Status: | Done |
| Project: | Instrument control development |
| Component/s: | ics_enuActor |
| Affects Version/s: | None |
| Fix Version/s: | None |
| Type: | Task | Priority: | Normal |
| Reporter: | arnaud.lefur | Assignee: | arnaud.lefur |
| Resolution: | Done | Votes: | 0 |
| Labels: | SPS | ||
| Remaining Estimate: | Not Specified | ||
| Time Spent: | Not Specified | ||
| Original Estimate: | Not Specified | ||
| Story Points: | 1 |
| Sprint: | SM1PD-2019 E, SM1PD-2020 A |
| Description |
|
SM1 red exchange mechanism is showing some problem since holding current has indeed been deactivated : after being set in position, either low or medium resolution, limit switch signal turns to 0 after some time. Since none of the limit switches are activated, rexm is therefore in an unkown position. SM2 rexm is now operational at LAM, i'm testing it to see if this behaviour is reproducible. |
| Comments |
| Comment by arnaud.lefur [ 17/Jan/20 ] |
|
Problem is indeed reproducible, winlight is now performing some test on sm3 |