[INSTRM-670] Track NIR readout serial numbers Created: 24/May/19 Updated: 19/May/23 Resolved: 19/May/23 |
|
| Status: | Done |
| Project: | Instrument control development |
| Component/s: | pfs_instdata |
| Affects Version/s: | None |
| Fix Version/s: | None |
| Type: | Task | Priority: | Normal |
| Reporter: | cloomis | Assignee: | cloomis |
| Resolution: | Done | Votes: | 0 |
| Labels: | SPS | ||
| Remaining Estimate: | Not Specified | ||
| Time Spent: | Not Specified | ||
| Original Estimate: | Not Specified | ||
| Story Points: | 1 |
| Description |
|
The visible DAQ chain saves the FEE, ADC, preamp, detectors serial numbers in the FEE NVRAM, and folks are pretty/very good about maintaining that. The FEE serial number can be read back and so provides the "root". We need the same for the NIR chain: SAM, cable, ASIC, cable, H4 ROIC. There is no place to save that, but we can at least read back the SAM serial number. So pfs_instdata/data/hx/$camera/daqConfig.yaml unless voted down. "hx" because the main writer is the "hxActor". Have a "serials" section with the obvious slots. |
| Comments |
| Comment by cloomis [ 19/May/23 ] |
|
This was done as part of other config file work. |