[INSTRM-1126] Update preshiprig test to check shipping preamp-ADC cable. Created: 03/Dec/20 Updated: 16/Dec/20 Resolved: 10/Dec/20 |
|
| Status: | Done |
| Project: | Instrument control development |
| Component/s: | ics_xcu_fpga |
| Affects Version/s: | None |
| Fix Version/s: | None |
| Type: | Task | Priority: | Normal |
| Reporter: | cloomis | Assignee: | cloomis |
| Resolution: | Done | Votes: | 0 |
| Labels: | SPS | ||
| Remaining Estimate: | Not Specified | ||
| Time Spent: | Not Specified | ||
| Original Estimate: | Not Specified | ||
| Story Points: | 2 |
| Sprint: | SM1PD-2020 N |
| Description |
|
The b2 amp swap problem uncovered a hole in the JHU testing, where the final preamp-to-ADC cable only gets tested during final integration right before shipping, and we do not check for amp or ccd swaps. But we can. At the start of the preshiprig test, clear the bias offsets stored in the FEE. This will show the stair step levels in the dummy CCDs, and thus point out any swapped amps within a CCD. After checking read noise, run a second image acquisition with the integrator held open on one of the CCDs. This will show amps swapped between CCDs. Needed for b3. |
| Comments |
| Comment by cloomis [ 10/Dec/20 ] |
|
ics_xcu_fpga merged at d22edf0 and tagged 82.2.0 |
| Comment by cloomis [ 10/Dec/20 ] |
|
Last note: holding the integrator open would have been useless, since that is done on the ADC. Instead, added a mechanism to hold the Summing Well open on one of the preamp sides. |